Part 3 - Preparing the case
Let's begin with the case.
- Remove the components from the box if not already done.
- Of the two supplied hex keys, use the smaller one to unscrew the case screws.
- Remove the top case half, and flip it upside down.
-
Unscrew and remove the temporary plate screws.
- Remove the plate from the case top half.
- At this point, the case should be disassembled enough for switch installation.
Prepare the plate and adhesive gaskets.
- Carefully place 5 of the long gaskets onto the plate, one per tab.
Note: For the minority who are planning on using aftermarket custom plates, install these gaskets on the case area where the plate tabs overlap; this applies to all gasket steps. For specific warnings and instructions, see here.
- Repeat on the underside; there should be 10 gaskets installed at the end of this step.
- Now prepare the sheet of shorter gaskets.
Carefully place 6 of these on the marked tabs.
- Repeat the process on the underside; there should be 22 total gaskets installed at the end of this step.
- Set the completed plate aside.